During this first time, the In-System programmer will apply its pull up to keep the MISO line stable until it is driven by the target microcontroller. Only after the “Programming Enable" command has been correctly transmitted to the target will the target AVR microcontroller set its MISO pin to become an output. When Reset is applied to the target AVR microcontroller, the MISO pin is set up to be an input with no pull up. This pin is always driven by the programmer, and the target system should never attempt to drive this wire when target reset is active.
When programming the AVR in Serial mode, the In-System Programmer supplies data to the target on the MOSI pin. Immediately after the Reset goes active, this pin will be driven to zero by the programmer. When programming the AVR or other SPI chips in Serial mode, the In-System Programmer supplies clock information on the SCK pin. To simplify this operation, the target reset is controlled by the In-System Programmer. When erasing the chip, the reset line has to be toggled to end the erase cycle. The target AVR microcontroller will enter Serial Programming mode only when its reset line is active (low). This is done by connecting ground of the target to ground of the programmer. The in-system programmer and target system need to operate with the same reference voltage.
Verify functions from the software screen.Īccording to the device information box from the software, signal connections should comply with the table below.įollowing is an example pinout of SPI EEPROM:
Display full path of network drive disk in file/folder browserġ0. Do not allow user to list project file during UFS/eMMC during copyingĩ. Enhance eMMC extCSD setting dialog in DediWare eMMC/UFS GUIĨ. Add more clear notification for swap under Edit Window.ħ.
Modify download project timeout to 250s.Ģ. Improve get socket info speed (get socket info before project running).ĥ. Fix NuProg-E verify fail, but report pass issue.Ĥ. eMMC project does not support blank check.ģ. DediWare General GUI shows IC partition name in load file list.Ģ.
K110 offers user the best solution for development and low volume production.īuilt-in high-speed processor to achieve high programming speed.
It provides online or offline Flash IC programming through the different adaptor. Powered by USB port and does not need external power, also provides Command Line for software redevelopment. K110 is an engineering IC programmer that supports the majority Flash ICs on the market.